Sometimes a more delicate approach is required as fish (especially on hard fished waters) will ignore or turn away from heavier dressed patterns such as the Deer Hair Emerger and this is when I reach for this wee CDC Olive Upright.
Still a very simple fly and straightforward to tie up it also gives a cracking wee footprint as well as rides low in that vulnerable in the surface style fish often pick out, with the subtle but definite small amount of flash thanks to the Olive Glister tied into the thorax dubbing material.
Great on slower flat glides but it’s equally successful on broken water although I often find it very difficult to see relying on my reactions to anything moving in the general area which can result in miss-timed strikes or even Trigger Happy ‘air shots’ when the fish wasn’t going for my fly at all.
On still water in a flat calm for ‘picky’ fish this wee fly can be the answer even if there’s not a lot of naturals around where the angler relies on the fish’s ‘Prey Image’ locking onto something that looks like a familiar food item, or perhaps just taking advantage of an easy meal.
To help keep the fly on the surface where it should be I treat the wing, thorax and tail with CDC oil applied to my finger then rubbed onto the wing, top side of the thorax and tail fibres, drying with ‘Amadou’ patch once it becomes waterlogged or after a bit of success with the fish.
Hook; Partridge Patriot Sproat G3AY size 12 – 16
Thread; Uni 8/0 Medium Olive
Tail; Nylon Paint Brush Fibres
Body; Tying Thread
Thorax; Medium Olive Hare, Rabbit, Glister Mix 45:45:10
Wing; Medium Olive CDC
Step 1 Lay bed of thread
Step 2 Select three or four paint brush fibres for tai
Step 3 Catch in tail and set length, take one turn of thread below to ensure they sit angled slightly up
Step 4 Form tapered body with tying thread
Step 5 Catch in a small amount of dubbing for thorax
Step 6 Form thorax and take a couple of turns of thread through to fully secure
Step 7 Select three olive CDC feathers and line up tips
Step 8 Set wing length and tie in feathers tight to thorax
Step 9 Trim waste CDC and store off-cuts to use on other patterns.
Step 10 Tidy head and secure CDC
Step 11 Take one or two turns thread behind CDC to ensure wing sits high
Step 12 Form head, varnish the thread to ensure thorax and CDC remain clean
Step 13 Brush out thorax slightly